Suppose there was once a project that required you to generate specific 3D models with complete dimensional parameters, draft fabrication drawings along with bill of material, and finally provide DEM simulation or structural analysis. And there is another project with the same nature of work, with the variable this time being the dimensions and/or the design parameters. What should you do? Devise the process with the same amount of effort all over again? Definitely not.
This kind of work needs to be done, there is no backdoor whatsoever. But what if the repetitive part can be automated, and what if only putting the design parameters would be enough to do the job and save valuable time. Now that's design automation right there.
A design automation software should be able to do the needed processes effortlessly. These processes being..
generation of 3D model
generation of fabrication drawing with BOM
generation of report(static structural or DEM simulation)
At BMHequip, we know the importance of cutting time and cost of manual labour, to improve the quality of work, and therefore are here to help you with that.
Comments